W3

Table of Contents

Installation

Table 1. Installation − General recommendations
A.svg

1. Use fixing screws, by hand, to attache the roof brackets on the t-rails of the lightbar bottom. Do not tighten.

B.svg
C.svg

2. Pre install lightbar with the brackets on the vehicle roof rails. The Standby label is placed on the lightbar FRONT part.

3. Aline the lightbar with the B-pillar.

D.svg
E.svg

4. Find a suitable location for the hole and mark its center.

5. Pre install the lightbar and brackets on the vehicle roof rails. Make sure that the lightbar top line is horizontal.

F.svg
G.svg

6. Adjust and tighten the fixing screws (brackets and lightbar).

7. Feed the lightbar cables through the vehicle roof.

I.svg

8. Fasten the lightbar top and mount the aerodynamic covers.



Table 2. Installation − Cannon connector as an option
A.svg

1. Use fixing screws, by hand, to attache the roof brackets on the t-rails of the lightbar bottom. Do not tighten.

B.svg
C.svg

2. Pre install lightbar with the brackets on the vehicle roof rails. The Standby label is placed on the lightbar FRONT part.

3. Aline the lightbar with the B-pillar.

D_Cannon_connector.svg
E.svg

4. Mark the location for the cable connector hole center.

5. Pre install the lightbar and brackets on the vehicle roof rails. Make sure that the lightbar top line is horizontal.

F.svg
H.svg

6. Adjust and tighten the fixing screws (brackets and lightbar).

7. Mount the Cannon connector. Bring the connector up through the lightbar bottom hole. Attache the four cables from the lightbar to the connector.

I.svg

8. Fasten the lightbar top and mount the aerodynamic covers.