Table of Contents

Factory Reset


The settings can be changed back to the factory settings. 

The factory settings are like the Preset settings.

Reset to Factory Settings


Risk of eye damage. Do not look into the light beam at close range.


All current settings, that is flash pattern setting and sync mode setting, are reset to the default settings.

  1. If already in configuration mode, go to step 6.

  1. If the lamp is connected to the power supply, disconnect it.

  2. Connect the red wire to 10-30 V DC via a 5 A fuse.

  3. Connect the black wire to ground.

  4. Within 1 to 6 sec: temporarily connect the white wire to ground and let it stay connected for at least 2 sec.


    The lamp enters configuration mode and a flash sequence indicating the current settings starts.


    If this step is performed incorrectly, you must restart from step 2.

  1. Fast temporarily connect the YELLOW wire to 10-30 V DC to enter the configuration mode for factory reset. A quick pulsating light indicates that the lamp has been changed from factory settings, slow pulsating light indicates that settings are according to the factory settings.

  2. The reset is confirmed with a bright flash light for 2-3 seconds.