Table of Contents

Sync Mode


The sync mode setting controls how the flashing of two or more lamps is synchronized. There are two versions of sync mode: Simultaneous and Alternate.

  • Simultaneous means that the lamps are in sync, that is they come on and go off at the same time.

  • Alternate means that the lamps are out of sync.

The preset setting of sync mode .

see Preset settings.

Slow flash shows simultaneous mode and quick flash shows alternate mode.

Setting the Sync Mode


Risk of eye damage. Do not look into the light beam at close range.

  1. If already in configuration mode, go to step 6.

  1. If the lamp is connected to the power supply, disconnect it.

  2. Connect the red (colour 1)/yellow (colour 2) wire to 10-30 V DC via a 5 A fuse.

  3. Connect the black wire to ground.

  4. Within 1 to 6 sec: temporarily connect the white wire to ground and let it stay connected for at least 2 sec.


    The lamp enters configuration mode and a flash sequence indicating the current settings starts.


    If this step is performed incorrectly, you must restart from step 2.

  1. Temporarily connect the blue wire to plus to change to the next version of sync mode. Each time the blue wire is temporarily connected to plus the next version of sync mode is selected. Slow flash shows simultaneous mode and quick flash shows alternate mode.

  2. To change the flash pattern setting, see Flash Pattern. To reset to factory settings, see Factory Reset.

  3. Disconnect the power supply to save the selected settings and exit configuration mode.