L52 2C

Table of Contents

Factory Reset


The settings can be changed back to the factory settings. 

The factory settings are the following (color 1/color 2):

  • Flash pattern - Double/Double

  • Sync mode - Simultaneous/Alternate

  • Input X2/X3 - Pull down/pull down

Reset to Factory Settings


Risk of eye damage. Do not look into the light beam at close range.


All current settings, that is flash pattern setting, sync mode setting and input X2/X3 setting, are reset to the default settings.

  1. If already in configuration mode, go to step 6.

  1. If the lamp is connected to the power supply, disconnect it.

  2. Connect the red wire to 10-30 V DC via a 5 A fuse.

  3. Connect the black wire to ground.

  4. Within 1 to 6 sec: temporarily connect the white wire to ground and let it stay connected for at least 2 sec.


    The lamp enters configuration mode and a flash sequence indicating the current settings starts.


    If this step is performed incorrectly, you must restart from step 2.

  1. Connect the BLUE and the WHITE wire to ground and let them stay connected for at least 2 seconds.

  2. The reset is confirmed with a bright steady light for 2-3 seconds.